They are available at Mouser I saw, not NOS yet. Me I had those from when I was collecting various VAS grade BJTs. Because plastic enclosed too, I thought they might solve the PSU oscillation pain in this kit after weighing the problem, still without Silpads and blind tare dangers given the peculiar sink situation. So it worked. But remember, in combination with "delete the 1uF capacitors parallel to the phono electrolytics". So I hope I contributed a little good practical idea.
That does not seem to be the case... I have D45H11, D45H11, 11P06, 20N06, D44H11, D44H11.... all alcaps, diodes and leds are positioned correctly (if the silkscreen is correct).
I am using the parts from the GB, but used J310's instead of the J109's supplied by the GB... are there any known 'wrong' parts in the GB or 'errors' in the silkscreen (e.g. I have to turn the legs of transistors etc)?
Yep... All seem correct (at least on visual inspection)... I could start replacing transistors, but the strange thing is that I get the same behavior on both boards... So most likely errors would be stuffing error, part selection/GB error, or pcb error (which can be ruled out).
Edit: another option is a problem in the preregulator, however it is 21v 30va transformer with a simple C filter (actually 18 x C per channel) which I had lying around. It is providing 29V plus and minus.... Seems all correct
Edit: another option is a problem in the preregulator, however it is 21v 30va transformer with a simple C filter (actually 18 x C per channel) which I had lying around. It is providing 29V plus and minus.... Seems all correct
PCB error can be out
Really cek all components again I did cek mine 3 times before soldering and a few more time while building it and still ended up with a capacitor the wrong way around that toke hours to find.
Did you measure the transistors and J fets before soldering?
Maybe a duff one there?
Really cek all components again I did cek mine 3 times before soldering and a few more time while building it and still ended up with a capacitor the wrong way around that toke hours to find.
Did you measure the transistors and J fets before soldering?
Maybe a duff one there?
Found the culprit: I had misunderstood the led orientation. It's a bit tricky, the symbols on the silkscreen seem to indicate the flat side of the led plastic to be on the anode side...
Now I need to replace all LEDs on two boards 🙁
Now I need to replace all LEDs on two boards 🙁
You learn something everyday, sometimes its a pretty experience, and some times it is 😡 But good to see you found it 🙂
just in case people are looking here - all subscribers for the new group buy have been contacted now, if you did not get a message please PM me
This one arrived today from my friend Werner @ Ireland:
Giddyup Go boy 🙂 Red Sovine - Giddy up go - YouTube
😀
But i've got another image in my mind >
Shane MacGowan And The Popes That Woman's Got Me Drinking with johnny depp - YouTube
But i've got another image in my mind >
Shane MacGowan And The Popes That Woman's Got Me Drinking with johnny depp - YouTube
As i said,
this picture with nicely glowing lights
arrived from the isle.
Everything good and well. 😀
The RIAA will be installed as soon as
my latest letter is beeing received there.
this picture with nicely glowing lights
arrived from the isle.
Everything good and well. 😀
The RIAA will be installed as soon as
my latest letter is beeing received there.
