Official M2 schematic

BTW, what do you use to separate the transformers when you stack them
together? I'm may need to do that for a vfet2 build but am unsure what
works well in practice.
Dennis

Each Antek transformer comes with two rubber pads. I used one on the bottom, two in between the transformers and one on the top. I have stacked transformers in my Aleph J and F6 builds without any issues. As you can see in a photo in one of my previous posts, I can rest the amplifier on one of the heat sinks and the transformers remain in place.
 
Received today few resistors for M2 Jfet stage.
They are like the labyrinth inside :cheerful:
 

Attachments

  • ADBD9034-73CA-4FE5-B22C-8DB94447E956.JPG
    ADBD9034-73CA-4FE5-B22C-8DB94447E956.JPG
    341.3 KB · Views: 902
  • 884C6822-728B-423C-965A-82A09B11102D.jpg
    884C6822-728B-423C-965A-82A09B11102D.jpg
    741.5 KB · Views: 925
  • F5EF7174-F55D-4450-BA14-C484AB618298.JPG
    F5EF7174-F55D-4450-BA14-C484AB618298.JPG
    973.9 KB · Views: 891
  • B095C21F-A9F6-4D9D-B9B5-4650A78592A8.JPG
    B095C21F-A9F6-4D9D-B9B5-4650A78592A8.JPG
    60 KB · Views: 844
Somehow I bookmarked two different BOMs for the M2 boards. Can someone skim through my list and make sure it looks correct for the tea-bag boards?

The IRFP240 and IRFP9240 are coming with the boards and the 2SK170BL and 2SJ74BL are coming from Spencer

An externally hosted image should be here but it was not working when we last tested it.


thanks!

Edit: the R10 and R12 should be quantity 4
 
Last edited:
awesome, thanks!


Here is what I have for the parts list for them. I'm planning to mount the LEDs in the front of the case (unless that isn't a good idea) next to a power switch.
An externally hosted image should be here but it was not working when we last tested it.

ta240,

If you have listed the parts for both rails of the power supply, you will need to increase the following:

- 505-MKS2.1/63/5 - total 8 units required
- 625-FEP30DP-E3 - total 8 units required
- 271-100-RC - total 8 units required