advice - when using any sort of signal iron , do not carve mains xformer place in stone
be prepared to be surprised
in other words - some tale chasing is pretty much inevitable , especially if you like high WAF cases (read - small ones)
be prepared to be surprised
in other words - some tale chasing is pretty much inevitable , especially if you like high WAF cases (read - small ones)
maybe it won´t hurt to put some rusty sheets of metal between turtle and trannie? but you already spoke of "real thick" qualities in this issue.
anyway, i´m prepared and will be open to play with positions
anyway, i´m prepared and will be open to play with positions
advisable in all times ..... things can get boring
(revisit ootoob from first post of thread )
actually , that first batch of plastickythingies (ABS) - enough bobbin elements for 15 bobbins , 10 covers
we'll see how many SE or balanced will be needed
no need for more , for starters
pcbs hopefully delivered end of next week ..... then mucho solderiiiiiiiiiiiiiiiiiiiiiiiiing
we'll see how many SE or balanced will be needed
no need for more , for starters
pcbs hopefully delivered end of next week ..... then mucho solderiiiiiiiiiiiiiiiiiiiiiiiiing
Attachments
An externally hosted image should be here but it was not working when we last tested it.
ZM was so friendly to also produce my own little amplifier (unity gain and unity current) on the remaining pcb space.
Totally transparent, no device in the signal path at all 😀
but take care before you order, it´s smd! and unfortunately much costlier that the iron pre 😀
thanks ZM! nicely done, but i´m looking forward to listen to yours also
stefan
