Hello Andrea,
please PM me with more details.
I am interested to learn&play first with these older versions, to warm up, to skill up, to familiarize on details and get more refined on issues... while in parallel I am interested for the new versions too.
For new versions of your source and doubler, do your see the date when a GB will be launched?
Thanks,
Ionmw
You can find detailed schematics and BOM for all the older oscillators in post #1506.
The new GB will start next month.
Hi Andrea,
Thanks for info about next GB and the pin-point place for all previous schematics and BOM.
I reacted also for your tip "Older versions are still available as bare boards and crystals". I assumed that a question like where to buy these old pieces (=free of old budget investments for you, and help to learn for me before next GB = win-win) it does not hurt. You can PM me if you have old units or excess BOM for resale and hence make more budget available for future cool developments.
Thanks,
Last edited:
I have no crystals in stock, some bare board only, so I think you have to wait for the next GB (coming soon). Also for the older versions, since I don't stock crystals.
Are they from Laptech (GB from this thread)? PM me with more details please.
Thanks,
I'm looking to buy 2nd hand crystals but I want to know if It can be used with the Chronus?
https://www.diyaudio.com/forums/swap-meet/353202-fs-laptech-crystal-tempered-master-clock-project.html#post6186999
Laptech crystals
https://www.diyaudio.com/forums/swap-meet/353202-fs-laptech-crystal-tempered-master-clock-project.html#post6186999
Laptech crystals
It seems that Chronus supports 45/49 MHz oscillator, from Twisted Pear Audio:
Cronus Re-clocking Module with 45.1584/49.152MHz Rhea Pair
Cronus Reclocking
So these not supported for Chronus?
1. 90.3168MHz SC cut 5th overtone
2. 98.304MHz SC cut 5th overtone
If I remember well miero said in one post Chronus can support till 100mHz but I'm not sure.
i was using an older version of master clock board.
keep in mind though, there are several versions of cronus too. i believe older versions dont support high freq clocks.
But not needed high frequency clocks for DSD512, I guess is enough with 45 & 49 & less jitter?
I think 1.4 should work with higher freq XOs.
What frustrates me is how poorly twistedpears are with their docs.
On the other hand, I shelved master clock board for 2 years. Came back to it, build it according to the docs. It works perfectly.
Thanks Andrea
Can I use yours 45/49 MHz oscillators togheter the Chronus?
Are 3.3V CMOS type clocks with ~50% duty cycle as twisted pear Chronus needs?
- Status
- Not open for further replies.