Just received my Toroidy transformer. I am a compete newbie here. I've asked a friend, but I'd like to confirm with you guys please. As you can see, secondaries are Red-Red, Brown-Brown.
So does red-red go to one bridge rectifier and brown-brown to the other rectifier?
Also, as this is 230v, UK voltage. Do I have one CL-60 on the live-neutral connector and x1 cap across the two white transformer inputs? I know this should be obvious, but want to double/triple check.
Thanks all for your much appreciated help!
So does red-red go to one bridge rectifier and brown-brown to the other rectifier?
Also, as this is 230v, UK voltage. Do I have one CL-60 on the live-neutral connector and x1 cap across the two white transformer inputs? I know this should be obvious, but want to double/triple check.
Thanks all for your much appreciated help!
Attachments
Yes, you are right about red-red and brown-brown.
Capacitor goes between the live and neutral. C60 goes on the live wire from the switch to the transformer. Perhaps pictures will help.
Capacitor goes between the live and neutral. C60 goes on the live wire from the switch to the transformer. Perhaps pictures will help.
Attachments
If Building an Aleph J with a 400va 18v transformer and 15Kuf 63v caps, can I use the Mur3020 diodes in the bridge section of the DiyAudio universal power supply?
I ask because I have them and heatsinks on hand.
Also would like to find values for the snubber resistor and cap RS1 and CS1 ?
I ask because I have them and heatsinks on hand.
Also would like to find values for the snubber resistor and cap RS1 and CS1 ?
- Home
- Amplifiers
- Power Supplies
- diyAudio Power Supply Circuit Board v3 illustrated build guide