I made this one, and labeled it - for 2 Donuts , each having 1 NTC per primary
so , 2 pairs of input wires , 2 pairs of output wires
with some simple ingenuity , it can be used for whichever arrangement you need it
post sketch of your intended Donut(s) , and I'll edit your sketch to accommodate your needs
so , 2 pairs of input wires , 2 pairs of output wires
with some simple ingenuity , it can be used for whichever arrangement you need it
post sketch of your intended Donut(s) , and I'll edit your sketch to accommodate your needs
before I spent some more cash on this addiction, can I use two 160VA, 2x18 @ 4A toroids I have in my stash, one for each channel for SissySIT? I may not get the full swing but I am OK with 10-15 watts/channel.
TIA
TIA
shoot for little lesser Iq , 1A5 or 1A6 and it'll be jolly - if these Donuts are of good quality , they will not complain with constant load of approx. 50% of their capacity
shoot for little lesser Iq , 1A5 or 1A6 and it'll be jolly - if these Donuts are of good quality , they will not complain with constant load of approx. 50% of their capacity
cool, thx zen, they are good quality custom made by Toroid Corp. of Maryland
Last edited:
SissySit is up and running thanks to ZM
Congrats, came together nicely.
.. dB
I am having a brain fart, how do I connect two 2x18 secondaries to the power supply board? use a dual power supply board? Four bridge rectifiers? Has been a while doing solid state...
Found these in my stash, tea-bag`s PS boards, so one board for each site (separately L and R channels), four bridge rectifiers, two 2x18 transformers feeding each board, complete independence. I will lift the boards and run the AC lines under all the way to front area where the toroids will live.
Attachments
the you're Happy Camper , same as I am with little ones I'm having inDEFiSIT
What a wonderful life to be the ever omnipotent, omniscient, omnipresent ZM. 😀
Found these in my stash, tea-bag`s PS boards, so one board for each site (separately L and R channels), four bridge rectifiers, two 2x18 transformers feeding each board, complete independence. I will lift the boards and run the AC lines under all the way to front area where the toroids will live.
Those are great PS boards. Use them in all my builds except F5, first diy Pass amp. My favorite power supply boards, tea makes them bomb proof.
Russellc
Thx Zen Mod, that is what I looked today. It is slightly different then my boards which don't have the holes for NTC C-60 or whatever thingies but I will add them on separate terminal blocks.
Started to do the adjustments with the help from Song. The left channel behaved and we were able to achieve the 20mV and 0mV input offset but the right side is stuck at 180mV and unable to go down. We used a variac and the input current draw was 400mV which seem high.
Any advice much appreciated.
Any advice much appreciated.
first confirm that you have 5V at output of 7805
then recheck all small diodes , number and orientation , take care of note for ZD1
proper placement of resistors is imperative , as always
then recheck all small diodes , number and orientation , take care of note for ZD1
proper placement of resistors is imperative , as always
- Home
- Amplifiers
- Pass Labs
- Babelfish M25, SissySIT - general building tips and tricks