Hi to all of you guys,i'm new here what i have been observe from the post was there are some schematic's posted,feedback is injected at + of LM311 and THEY OTHER WAY AROUND - NEG.If we are talking OSCILLATION guy"s is this negative injected feedback can make oscillation frequency higher?regardless the RC feedback CIRCUIT,Andrewlebon posted schematics with ref. OSCILLATOR & protection circuit are there any advantage of using this circuit compared to the other schematics posted here,thank's.
Yes there are...faster switching...smaller inductor,less high frequency cuttoff but lower efficiency.
thank's CPX, any suggestion from andrewlebon circuit?beacause I'm interested,the clocking version look's like pure CLASS D audio amplifier,please correct me if i'm wrong.
HI ANDREWLEBON i'm interested on your design,planning to build one.Can you post some wave form from oscilloscope,does the ref. oscillator makes more clearer P.W.M. output.thank's a lot Anrewlebon,hope to hear more from you.
andrewlebon avoid tl071 .. i recomand a simetrical inverting non inverting amplifier with lm833
We're welcome.
You can even use ultra low noise opamps if you find you ucd noisy,decrease lm311 gain to 5x and increase its supply rails to +-15v and use this modified circuit to obtain total gain 25x with global noise much better than with standard lm311 with gain of 25.
You can even use ultra low noise opamps if you find you ucd noisy,decrease lm311 gain to 5x and increase its supply rails to +-15v and use this modified circuit to obtain total gain 25x with global noise much better than with standard lm311 with gain of 25.
An externally hosted image should be here but it was not working when we last tested it.
Last edited:
ok, i`ve some issue when up the gain of the op-amp, it will distort the input signal if the gain is too much even at low volume, so i think need to find out the maximum gain can be accepted for each amp, 25x gain lol its too much i think, but i like ultra low noise.
regards.
regards.
Yes gain 10 is good..but snr is better with gain decrease if you use a ultra low noise op amp befere ...
If you decrease gain you have to increase lm311 supplies to avoid clipping..for gain 10 and +-12 volt suplies you can have maximum 60 volt rms output,for gain 5 you can have maximum 30 and so on...for gain 5 and +-6 volt you can have maximim 15..etc
If you decrease gain you have to increase lm311 supplies to avoid clipping..for gain 10 and +-12 volt suplies you can have maximum 60 volt rms output,for gain 5 you can have maximum 30 and so on...for gain 5 and +-6 volt you can have maximim 15..etc
bridging ucd amplifier
Hi Cpx
greetings thanks for sharing schematics
warm regards
andrew lebon
Hi Cpx
greetings thanks for sharing schematics
warm regards
andrew lebon
HELLO
Hi Manojtm
greetings whats power of amp at 80 volt dc supply and is it suitable for 2 ohms load nice work
warm regards
andrew lebon
Hi Manojtm
greetings whats power of amp at 80 volt dc supply and is it suitable for 2 ohms load nice work
warm regards
andrew lebon