Thanks Peter, I will give it a try. Will the opamp fit on a regular project board that I can get from Radio Shack?
Member
Joined 2002
Hey all.
Well, Peter, all I can say is that every time you put forth a design it is always well thought out and truly professional looking...Congrats on that!
I am considering building one of these to replace my ARC PH3SE, which, while a truly nice piece of gear, just doesn't really have enough gain for the LOMCs that I enjoy using.
I am wondering - has anyone done any subjective comparison between this and any other good phono stages? I have quite a bit of listening experience with the Pass Xono, Whest 2, Rossner und Sohn, but ultimately would like to build something...
Regards,
Byron
Well, Peter, all I can say is that every time you put forth a design it is always well thought out and truly professional looking...Congrats on that!
I am considering building one of these to replace my ARC PH3SE, which, while a truly nice piece of gear, just doesn't really have enough gain for the LOMCs that I enjoy using.
I am wondering - has anyone done any subjective comparison between this and any other good phono stages? I have quite a bit of listening experience with the Pass Xono, Whest 2, Rossner und Sohn, but ultimately would like to build something...
Regards,
Byron
Well, I know a guy who used to listen through ARC PH7 to his heavily modified Versa Dynamic with ZYX Universe. After he tried this phono stage, he "hates" going back to PH7 😉
Last edited:
HI Peter
not sure from the thread but is the kit ready to be bought??or just the boards? if so how much?
Usual paypal address?? Amount with postage to UK?? etc etc.
not sure from the thread but is the kit ready to be bought??or just the boards? if so how much?
Usual paypal address?? Amount with postage to UK?? etc etc.
The boards are $40/pc plus $6 shipping, usual paypal address.
I still didn't decide on a kit as a total cost is quite high, but for now, I can supply most of the parts including V-Caps. No BGs though, as sourcing them presently is practically impossible.
I still didn't decide on a kit as a total cost is quite high, but for now, I can supply most of the parts including V-Caps. No BGs though, as sourcing them presently is practically impossible.
They used to be on ebay at $2.50/pc but I don't see them any longer. I got mine through a friend from a supplier in Poland.
You can also get them from me at $2.50/pc
You can also get them from me at $2.50/pc
It does 😉
The J511 isn't as expencive to you as it looked......
I was just wondering if there was any benefit from using a €10.00 component there, when you can get a similar for under €2.00 🙂
The J511 isn't as expencive to you as it looked......
I was just wondering if there was any benefit from using a €10.00 component there, when you can get a similar for under €2.00 🙂
I was able to get the J511 from HK, 4 for $10. Also, the 1N5314 really is easy to get. In fact the hardest part for me was remembering which IEC inlets would fit Peter's boards. Got some that were too thick, so if I were to make a recommendation on the BOM, it would be to put in the PN for the IEC inlets that fit.
