+1. If you want to be taken seriously in these forums you better post something a little more constructive..Show us your design(s).
Initial SSR3 documentation. Please report errors and ask questions 🙂 Thanks.
Any errors reported?
I am going to order some boards in the next few days... 🙂
no report
latest wiring diagram
What should be the VA rating of aux transformer to run two boards.
One module requires approximately 25 mA, so any small 2-5 VA transformer can do the job. I recommend regulated psu (LM78xx,LM317).
oknewer is on the left (published gerbers), right one is the "beta" version
Thanks🙂
A short circuit can damage the mosfets in the SSR. (depending on the magnitude and duration of the current).
I want to warn everyone to use some current limiter and overcurrent detector in conjunction with SSR3.
The limiter current should be greater than the detector threshold current (which then activates the load/short disconnection).
I want to warn everyone to use some current limiter and overcurrent detector in conjunction with SSR3.
The limiter current should be greater than the detector threshold current (which then activates the load/short disconnection).
Simple and cheap solution is a fuse.
Maplin had one in the output of their 225WRMS Disco amplifier.
Maplin had one in the output of their 225WRMS Disco amplifier.
Hi LKA what will be the case that my circuit having a periodically noise when connected to an amplifier.
This occurs to one channel only.
Swapping the boards the problem is still to the same protection board.
The other protection board works perfectly.
Noise is like an old t.v without a an antenna input.
It is audible even without music signal input.
This occurs to one channel only.
Swapping the boards the problem is still to the same protection board.
The other protection board works perfectly.
Noise is like an old t.v without a an antenna input.
It is audible even without music signal input.
Last edited:
Interesting. Is it a dual-mono amp or single supply ?
It is a single supply but problem is the same even if the other chanel isn't connected ,power supply connected to one chanel only.
- Home
- Amplifiers
- Solid State
- SSR for speaker protection?