Power supply working
Got 2 0.22ohms resistors for rf and everything is working fine. Adjusted voltages without load and after connection to load. Will check them later. It looks like soundstage is larger and more air, so far. Only 10 minutes playing!
Got 2 0.22ohms resistors for rf and everything is working fine. Adjusted voltages without load and after connection to load. Will check them later. It looks like soundstage is larger and more air, so far. Only 10 minutes playing!
Attachments
I don't know for sure because I haven't tested the 33uF 25V one. But given the fact that in 33uF 50V it has only 0.12Ω 100kHz ESR I wouldn't expect it in 25V to measure ESR beyond the recommended range although it should be higher than in the 50V. The 47uF 35V ES has 0.13Ω ESR for example.
P.S. I have read that the longer lead in the Nichicon ES bipolar is the outer foil for anyone interested. So you may prefer to solder the longer lead to the ground plane pad. For C3 that's the figure of eight double pitch pad. For C2 the single pad.
P.S. I have read that the longer lead in the Nichicon ES bipolar is the outer foil for anyone interested. So you may prefer to solder the longer lead to the ground plane pad. For C3 that's the figure of eight double pitch pad. For C2 the single pad.
Those 1R & 2R you ordered are wrong. At least you asked while still in time. They would have produced much shunt current for that DAC as load and excessive heat. Not to mention limiting the stability. Setting for Soekris has been discussed before in this thread (post#129).
- Home
- Amplifiers
- Power Supplies
- Salas SSLV1.3 UltraBiB shunt regulator