Aleph J: Phase 1
I never thought I would be able to do this myself, but it was easier than I had expected. I will have a while to wait to see if I got everything done properly, because I have lots to do before I can test the pcb.
Next phase is the enclosure. I have to figure out how to drill and thread holes in the heat sinks. Never done that before, so should keep me busy for a while.
I never thought I would be able to do this myself, but it was easier than I had expected. I will have a while to wait to see if I got everything done properly, because I have lots to do before I can test the pcb.
Next phase is the enclosure. I have to figure out how to drill and thread holes in the heat sinks. Never done that before, so should keep me busy for a while.
Attachments
Your gonna love it. Very romantic amplifier. Still maybe the best I have heard 500hZ and up. Then again, I haevnt heard but a few
I have an original Aleph 3. It is beautiful and is powering mid/hi on my Magnepan MG3A's.
I am looking forward to comparing the Aleph 3 with the Aleph J. I do worry though, that the J might run out of steam. I decided to build to the original J specifications (except slightly higher rails from 21V secondaries). The Maggies are 4 Ohm and the standard J does not like 4 Ohm.
hi and thanks pcb. I dont actually have to much information on the cooling as this was something that was going to get thrown away. it splits into 4 parts and have alot of surface are inide. My colleague told me it was good for about 1000 watts. The plan is to use a fan from this review Recommended Fans | silentpcreview.com , hopefully i can manage to get a tolerable dB level
My colleague told me it was good for about 1000 watts.
Very unlikely if you are building something from Nelson Pass.
Sven
Very unlikely if you are building something from Nelson Pass.
Sven
that depends, could be something designed for ~100-150W per channel output, that would need to cope with ~1000W of heat =)
Very unlikely if you are building something from Nelson Pass.
Sven
1000W dissipation is 1000W. no matter if it is pass design or krell or what not.
- Home
- Amplifiers
- Pass Labs
- Pictures of your diy Pass amplifier