For 25V operation you'll need to replace the two 15K resistors with 12K.
Last edited:
Hi Shaan!! I think next month you have some news from me!!
Now, I've found a problem... in the first page, schematic haven't trimmers...
Now, I've found a problem... in the first page, schematic haven't trimmers...
Hey there franz!
News about what? 😛
The schematic shown in the first page is for the very first PeeCeeBee V1 and it doesn't have any trimmers.
I know, but if someone want to build it, should have the final version (I think!).
Mosfet from Tayda are lost.... next month I must receive another shipment (I hope!)
Mosfet from Tayda are lost.... next month I must receive another shipment (I hope!)
Hi Shaan
Im also interested as Im already a fan of your V3!
Sent from my GT-N7100 using Tapatalk
You're right. But don't worry the first post has the links and pics for V1.1/V2/V3 right at the beginning. 🙂
Thats strange, few moths ago when I checked Tayda was showing >100,000 in stock for both mosfets..
Had been having a hard time with time. One of the boards gets populated, ready to be tortured.
Looks good eh? 🙂
Black beauty [emoji1303]
Tapatalk kullanarak iPhone aracılığıyla gönderildi
Had been having a hard time with time. One of the boards gets populated, ready to be tortured.
Looks good eh? 🙂
Nice clean soldering.
Had been having a hard time with time. One of the boards gets populated, ready to be tortured.
Looks good eh? 🙂
what are the advantages of v4 over v3?
thanks
So far the veroboard prototype showed better bass, better thermal performance, better bias stability, better clipping performance, higher slew-rate, lower THD and higher gain allowance.
🙂