Hello Again,
I have been searching through my documentation and have found a third construction manual! This one is 19 pages and is entitled K1100 Series Power Amplifiers - Version 2. I suspect this is a later version still. Again, I am happy to scan it, if you let me know.
Best wishes
I have been searching through my documentation and have found a third construction manual! This one is 19 pages and is entitled K1100 Series Power Amplifiers - Version 2. I suspect this is a later version still. Again, I am happy to scan it, if you let me know.
Best wishes
Hello members
Have just made a little soft start module for the 500va transformer that I am using for this project
It has mains in (top right corner terminal)
then terminal for the main on/off switch and out put to fans and protection modules and from the red circuit board goes to the primary transformer winding
hope this makes sense
Have just made a little soft start module for the 500va transformer that I am using for this project
It has mains in (top right corner terminal)
then terminal for the main on/off switch and out put to fans and protection modules and from the red circuit board goes to the primary transformer winding
hope this makes sense
Attachments
Also Please note :
the power supply PCB has a very small over site that is easily rectified (yes I have not the time to re visit the Gerber file)
this PCB 1150-3 has been modified to take the latest power supply capacitors and a small copper wire / track was left off . This is very simply added at the assembly stage by taking the cathode wire from D11to the base (centre) connection of Q14
the power supply PCB has a very small over site that is easily rectified (yes I have not the time to re visit the Gerber file)
this PCB 1150-3 has been modified to take the latest power supply capacitors and a small copper wire / track was left off . This is very simply added at the assembly stage by taking the cathode wire from D11to the base (centre) connection of Q14
@jamesfeline
Please find attached the latest construction maunual I have. I believe it relates to the same version of boards that you are using. Unfortunately, the circuit diagrams are not very clear as Hart used scanned copies from the original magazine articles. Hope this helps?
BTW - Your thread reignited my interest in this amp to the extent that I got it out, checked it over and had a listen. It's 30 years old, still works and sounds good! I also have a pair of bare Hart power amp boards so am considering building it again as I feel I could probably make a better job of it now!
Best wishes
David
Please find attached the latest construction maunual I have. I believe it relates to the same version of boards that you are using. Unfortunately, the circuit diagrams are not very clear as Hart used scanned copies from the original magazine articles. Hope this helps?
BTW - Your thread reignited my interest in this amp to the extent that I got it out, checked it over and had a listen. It's 30 years old, still works and sounds good! I also have a pair of bare Hart power amp boards so am considering building it again as I feel I could probably make a better job of it now!
Best wishes
David
Attachments
@didyman
Yes, the Hart manual is practical and straightforward. I am no expert but managed to successfully build the amp using it. Good luck with your build!
@jamesfeline
You are welcome!
Yes, the Hart manual is practical and straightforward. I am no expert but managed to successfully build the amp using it. Good luck with your build!
@jamesfeline
You are welcome!
Time for BOM. I have all ideas about almost all components, but what about resistors? Metal-evaporated ones I think we prefer, even in power resistors. Dale, or other brand? Also have to find an idea about polycarbonate capacitors. I have never used them, wich brand is preferred? And, for Gate stoppers, I will not use SMD because of heat related mechanical problems. I plan to use through hole ones with dedicated low inductance types, but open for discussion.
- Home
- Amplifiers
- Solid State
- JLH Mosfet Power amplifier construction thread