10 in lb = 1.1 nm
5 in lb = .6 nm
.8 ft lb = 1.08 nm
Looking at TW’s that can do that range from $50-150….wow. I’ll stick with “feel”.
Besides I have my snap-on for cars & motorcycles.
5 in lb = .6 nm
.8 ft lb = 1.08 nm
Looking at TW’s that can do that range from $50-150….wow. I’ll stick with “feel”.
Besides I have my snap-on for cars & motorcycles.
You own a sports watch? Turn it on and tighten the M3 till the watch says you burned 1 joule. Shouldn’t that work, ZM?
Ok, please suggest a wrench!
I'm going to use mica+goop, so 1.?
I was thinking about this one maybe.
SHAHE ZSQ Preset Torque Screwdriver Adjustable torque wrench High Quality Wrench Hand Tools|Screwdriver| - AliExpress
Yeah.
But it helps here in Russia because customs tax is only added to the goods only and not to the shipping.
Good point. They don't tax/duty anything under $20 inbound here. In reality its fairly often they let slip taxes for anything under $100. Over that they want their pound of flesh.
Hmm. Marketed a a firearms torque wrench in the USA. Why am I not surprised?
https://www.amazon.com/PORMUCAL-Fir...ords=Torque+Screwdriver&qid=1629998517&sr=8-7
https://www.amazon.com/PORMUCAL-Fir...ords=Torque+Screwdriver&qid=1629998517&sr=8-7
Pass DIY Addict
Joined 2000
Paid Member
Wait. With a single ended configuration IN- is supposed to be run to GND as well as lead going back to the input connector?
Currently I have IN+ and IN- just both running back to the input connector. Assuming that's why I got a huge hum off the my DAC source (I don't bother with a pesky pre) until I equalized its chassis ground back to my power filters GRD terminal.
Currently I have IN+ and IN- just both running back to the input connector. Assuming that's why I got a huge hum off the my DAC source (I don't bother with a pesky pre) until I equalized its chassis ground back to my power filters GRD terminal.