than's mr apex
Thank you mr apex.the h 900 sounds incredible. i made a smps for it with +/-90v and +/-50 volt that's way i ask for biasing.my idle current is too low.thank you again.
Thank you mr apex.the h 900 sounds incredible. i made a smps for it with +/-90v and +/-50 volt that's way i ask for biasing.my idle current is too low.thank you again.
apex,
please label the trimmer pots 1,2,3 in the schematic,
bourns like this best fit in pcb space,
just please help us determine w/c is 1 ,2 , 3
please label the trimmer pots 1,2,3 in the schematic,
bourns like this best fit in pcb space,
just please help us determine w/c is 1 ,2 , 3
Attachments
Last edited:
look at the side/face of the trimpot it is there...on the scheme start from the top....1....2 is center.....3 is bottom pin...
sir tony,
yes sir no problem with the trimpot clockwise wiper ccw (1,2,3)already labeled,how to apply it on ckt. is what i mean,better label the schematic with 1,2,3 for better understanding/application.
yes sir no problem with the trimpot clockwise wiper ccw (1,2,3)already labeled,how to apply it on ckt. is what i mean,better label the schematic with 1,2,3 for better understanding/application.
hy diy-ers
hy guys. the smps is not my design but i adapted for me .the smps it takes +/-50v,+/-90, +/- 24 v for protection board,and +/-12v for other accesories`i put 2x200watt bulb with h 900 and the bulb don't flicker at all .it's verry stabile.i will share the design and some pictures as soon as posible. thank's to mr apex i will build some active line array speaker just for testing but this when i have more time. bye
hy guys. the smps is not my design but i adapted for me .the smps it takes +/-50v,+/-90, +/- 24 v for protection board,and +/-12v for other accesories`i put 2x200watt bulb with h 900 and the bulb don't flicker at all .it's verry stabile.i will share the design and some pictures as soon as posible. thank's to mr apex i will build some active line array speaker just for testing but this when i have more time. bye
engel dela pena
engel dela pena you can use BYW54,i use this too and it's ok.maybe it's easy to find in your area.
engel dela pena you can use BYW54,i use this too and it's ok.maybe it's easy to find in your area.
looking at datasheet the only difference is bav21 is 250v while bav20 is 200,
i already use what apex post before mur120,and uf4004
i already use what apex post before mur120,and uf4004
hy
cristi,first the smps is 220$ that is too expensive......and it's more imortant to diy the smps.in fact that's way we are here 😎
cristi,first the smps is 220$ that is too expensive......and it's more imortant to diy the smps.in fact that's way we are here 😎
Apex sorry if this question has been here more than once but how much uF would you sugest for the MV? would 30 000 uF be enough, atleast I think so...
