Hello everybody. Please tell me the parameters of the coil for APEX A40. I tried to find it by search, but did not find it. Thanks in advance.
I used this pcb:
I used this pcb:
Attachments
Last edited:
After looking at many of the builds that have the 2SC5200 and 2SC1943's, which are not only hard to get where I am, but also a but of a gamble, how would the Tip35 and TIP36's be as a replacement? Would that depend on the circuit or is it a good general replacement? I came across this website, which suggest these as replacements for them
Marc's Hobbies: Amplifiers
Marc's Hobbies: Amplifiers
Mile thanks a lot. And thanks for all that you do. With great respect, Evgeny.
I posted gerber files for AX-11 here - it is based on previous designs posted
here...pcbs came out good from JLCPCB, but I am yet to complete my build and
verify them.
https://www.diyaudio.com/forums/sol...mate-fidelity-amplifier-1253.html#post6159943
f100 fx100 psu
hi all and mr. mile
i was making f100 psu i finish the pcb but its too late i see there is another same psu just changed protec fx100. f100 not recomended for use long time? or is it not safe? i will use it with ax14.
can i use f100 psu or need to make another pcb for fx100 psu.
thank you.
hi all and mr. mile
i was making f100 psu i finish the pcb but its too late i see there is another same psu just changed protec fx100. f100 not recomended for use long time? or is it not safe? i will use it with ax14.
can i use f100 psu or need to make another pcb for fx100 psu.
thank you.
Attachments
Hi guys. Anybody got the SPRINT files for the APEX PSU15? Or maybe you could link them... 🙂
Would appreciate it
Would appreciate it
Gosh, what program are you guys using to open the Gerber files? I tried Eagle, and Sprint, no luck.