Great Job!
Very nice PCB! Very DIY friendly PA amp. Any load/short/dc protection suggestions for this amp?
regards
Very nice PCB! Very DIY friendly PA amp. Any load/short/dc protection suggestions for this amp?
regards
Thanks.....
Sure! Here it is......
Regards,
Beautiful as always. Can you share PCB in IMG or PDF? pls 🙂
Regards
Sure! Here it is......
Regards,
Attachments
Wow ready for PCB etching, I hope I could assemble this amp too...
Great effort wiljj78 !! Keep it up!!!
Regards,
Angeltech
Great effort wiljj78 !! Keep it up!!!
Regards,
Angeltech
while you work on the real thing, here is some box 'considerations' for my own downscaled 'personal version'
I suggest two mono blocks 🙂
Attachments
It's my pleasure...
Most welcome guys....
Please let me know if you found any mistake so we can correct to make this successful project and good working amp by APEXAUDIO corporation....
Good Luck and Enjoy....
Regards,
Most welcome guys....
Please let me know if you found any mistake so we can correct to make this successful project and good working amp by APEXAUDIO corporation....
Good Luck and Enjoy....
Regards,
Most welcome guys....
Please let me know if you found any mistake so we can correct to make this successful project and good working amp by APEXAUDIO corporation....
Good Luck and Enjoy....
Regards,
Thanks Wiljj78 & Mr. Mile for sharing...🙂
Regards to all...
Last edited:
Only one suggestion for Willy 🙂
Noted Mr. Mile...
Will revise that and repost tomorrow.
Regards,
Last edited:
Pots for bias and dc offset can be add 🙂
Attachments
Last edited:
Pots for bias and dc offset can be add 🙂
For bias add 5k pot, for dc offset add 1k pot and replace R4 with 470R (instead 1k).
Got it...
Q7 and Q8 I think need to rotate.
Yep, that's correct. But if you use MPSA42/92 you don't have to correct that mistake. 😉 😀
Last edited:
- Home
- Amplifiers
- Solid State
- 1000W Simple PA Amplifier