I was just looking at them. They don't match. C13 and C14 on the board are C16 and C17 in the schematic.
Tnx. Got a little confused there for a moment.
I read in the honeybadger thread that mjl21193/94 are too slow for the EF3 amp. I was planning to use those transistors from a hk690 (ef3?) in this build. Are they a no go or will they work for music?
I read in the honeybadger thread that mjl21193/94 are too slow for the EF3 amp. I was planning to use those transistors from a hk690 (ef3?) in this build. Are they a no go or will they work for music?
I'm trying to get Kypton V up and running. Something seems to be very wrong. None of the leds light up. If I disconnect NFB, one of them light up.
Any suggestions where to start troubleshooting?
Any suggestions where to start troubleshooting?
-0.665v with NFB disconnected. -0.445 with NFB connected.
Drop across it is 1.314 in both conditions.
Drop across it is 1.314 in both conditions.
This one's a bit of a nightmare to figure out by just staring at the schematic. You should have twice as much current flowing through R9. I think Q3/4 aren't drawing enough current.
I'll sit down and double check all values with the schematics. I suspect that there can be a wrong value resistor somewhere.
This input is very similar to Valery's TubSoMo. I had one of those operating the same. I fought with it for a couple days, then threw it behind the tire of a loader as it backed up.😡
Me and Thimios shot back and forth many times on the V. We finally
came up with the V2 (below).
The V is VERY picky about compensation (R6/C3 - R12/C13).
He said (and showed) it worked , said it was one of the better sounding IPS's.
OS
Attachments
Hello , Thimios.
I am almost sure my posted "V2" is where you had it "singing" 😀 .
Right ??
I did update the R13 (servo FB) to coincide with the other
servo'ed IPS's (symasui/spooky) 5.6K Z allowed for millisecond settling.
Both my Symasui and spook settled to .1mv within <100mS with this
value.
OS