The dumb-O-tron

Status
Not open for further replies.
The magic is in the circle
Started building this today.
Hopefully have it finished by tomorrow.
I will release the circuit if it sounds good
 

Attachments

  • 09062012183.jpg
    09062012183.jpg
    33.2 KB · Views: 882
  • 09062012184.jpg
    09062012184.jpg
    26.4 KB · Views: 856
Last edited:
Wasn't sure what was going on here. I thought I might have had a ground loop, or maybe I needed teflon pcb material.
In the end I worked out what the problem was.
Just needed a screw driver.
 

Attachments

  • 10062012187.jpg
    10062012187.jpg
    36.1 KB · Views: 765
Just got it up and running, but the bias jumps like a rocket when I plug the xlr cable into the amp. Need to think what the hell is going on. Not sure whether the signal input should be grounded through a resistor. The supplies are floating
 
Last edited:
If you have Jfet input, any preamp offset would affect bias. Rothacher talked about importance of signal grounding as well as symmetry of two sides to maintain balance. Without circuit, just guessing. With circuit, still guessing:rofl:
 
Status
Not open for further replies.