Yes but unless there is a lot of deadtime programmed in, you'll have to go to 47 ohm gate resistors.
That looks OK but doesn't tell you about deadtime. If you install the 3205s and they run hot at idle and full duty cycle (I don't know if this amp has regulation, for the rails), you'll need to replace the gate resistors with a lower value (generally 47 ohms).
I changed the gate resistors to 47 ohm and put in some 3205’s and the amp draws excessive current
I pulled the rectifiers amp still draws excessive current.
Checked the outputs they all test fine .
Tried twisting the transformer no change
Checked the outputs they all test fine .
Tried twisting the transformer no change
- Home
- General Interest
- Car Audio
- Sundown SAE-1000D