50W instead of 100 , per heatsink , will tell you nothing
remember that things aren't linear in thermal system
i accepted the idea of going dual mono, so it would be the one tokin per sink for real
yes, its already mounted and me almost concious : ) (but i´m just afraid to make it with 50k volume pot, there is too small region to trim), i´ll try to get a multiturn 10k today.
another one, when i took off the F6 PCB from heatsink, having been insulated with keraterm, i saw little holes in the pad, obviously not so good idea to use them twice!
another one, when i took off the F6 PCB from heatsink, having been insulated with keraterm, i saw little holes in the pad, obviously not so good idea to use them twice!
I believe you'll find Keratherm in 10x10cm format at Conrad.de
though , that damn thingie is so massive , for 50W of heat , evem 0.1mm thick mica is overkill , with goo of course
I'm regularly using punch method for opening holes in mica , in this case nice** M5 bolt (as punch) and M5 nut (as female ) will do the job , if you find mica sheets
**means proper clean forehead of bolt
edit: just imagine I break this post in 4 separate ones , and everything is easier to grasp
though , that damn thingie is so massive , for 50W of heat , evem 0.1mm thick mica is overkill , with goo of course
I'm regularly using punch method for opening holes in mica , in this case nice** M5 bolt (as punch) and M5 nut (as female ) will do the job , if you find mica sheets
**means proper clean forehead of bolt
edit: just imagine I break this post in 4 separate ones , and everything is easier to grasp
edit: just imagine I break this post in 4 separate ones , and everything is easier to grasp
just finished the "conrad" part, feel exhausted, 'nough for today
happythanx!
camera in studio also, me not havin smartphone, but this wasn't bad either : )
An externally hosted image should be here but it was not working when we last tested it.
- Home
- Amplifiers
- Pass Labs
- SissySIT