I am trying to replace the power connector for something better (at least that is what I think, see picture below) on my clone NHB-108. Seemed like an easy swap, but unfortunately it was not that easy: the existing terminals/spades do not seem to want to be removed. I am probably missing something here, but how do I remove these undamaged from the exisiting connector?
Also, would these fit the new connector anyway?
Also, would these fit the new connector anyway?
Never mind, I also replaced the internal power cables and spades. For those who might be interested and see how the power circuit looks like some pictures.
Still curious though, how can the spades be removed from the old connector?
Still curious though, how can the spades be removed from the old connector?
