Record Player/Turntable Kanoot from Moth Group - Motor Pulley for 50 Hz needed

[tiefbassuebertr]

A 60 Hz motor used with a lower frequency is less efficient. It is the
same as with a mains transformer. I can not recommend using a
dedicated 60 Hz motor at 50 Hz.

Actually the manufacturer should have been even a 50Hz version of the motor in image No 3 from post # 13.

 

[MAF]

Yes, thank you very much in advance.
Check post #14 the ordering address.

Hello

Sorry for terrible delay.
Here are belt dimensions:
d=2mm
length(in working position) 950mm
length 915mm

Hope, it would help.

Once again, sorry for delay.

 

[tiefbassuebertr]

Hello

Sorry for terrible delay.
Here are belt dimensions:
d=2mm
length(in working position) 950mm
length 915mm

Hope, it would help.

Once again, sorry for delay.

thank you. Maybe this one will be good:
https://www.thakker.eu/riemen/auf-mass/round-belt-290-0-x-2-0-circumference-911-mm/a-373/

 

[MAF]

thank you. Maybe this one will be good:
https://www.thakker.eu/riemen/auf-mass/round-belt-290-0-x-2-0-circumference-911-mm/a-373/

That's the one, I think. Pretty close at least.
But let me tell you this.
Friend of mine has Transrotor TT. And after he installed the new belt wow and flatter increased up to 0.20%.
Not sure was it Thakker or not, but there is a fact.

 

[tiefbassuebertr]

That's the one, I think. Pretty close at least.
But let me tell you this.
Friend of mine has Transrotor TT. And after he installed the new belt wow and flatter increased up to 0.20%.
Not sure was it Thakker or not, but there is a fact.

The 911 mm Thakker belt provide similar results, i. e. lower value for circumference is necessary for lower slip.

Measuring the length (whole circumference in stretched condition) according method number 2. under
https://vacationvinyl.com/how-to-me...d is one of,measure its length in millimeters.
i. e. motor pulley and platter outer diameter together provides a length value of 923mm.
I guess, this means a circumference below 900 mm (maybe 850 mm).

I ask via email the value for this belts and look forward for the replies:
https://www.analogueseduction.net/p...t-xperience-replacement-drive-belt-round.html
https://www.lpgear.com/product/MOTHKANOOT.html

 

[tiefbassuebertr]

what difference is between red and black belt (same size - go to the attached images) ?
Best thanks for an information

 

[tiefbassuebertr]

Are there a difference between the turntables "MOTH SUPER OAK", "OAK Audio" and Moth OAK ?
According the attached images - found under canuckaudiomart (first both) and facebook (third image) and closed ebay auction (last image) this turntables are identical models, but I am not absolutely sure.