Not yet. Mine is slated for an Adcom GFA 585LE, but I need to order header pins and sockets for the instant-off board. I have a cabinet full of Molex connectors - not one of them is correct.
Has anyone installed one and tested it out yet?
Someone sent me a PM asking what are the Mouser part number for Faston tabs for the speaker out/amp in and the 2-pin Molex KK housings needed for connecting the power input or logic controller input.
TE Connectivity 0.250 PCB Tab (AMP Faston spade), Mouser P/N: 571-624091
Molex KK Housing, 2 postiion with Ramp/Ribs, Mouser P/N: 538-22-01-3027
Molex KK crimp connectors 22-30 AWG socket, Mouser P/N: 538-0850-0032
TE Connectivity 0.250 PCB Tab (AMP Faston spade), Mouser P/N: 571-624091
Molex KK Housing, 2 postiion with Ramp/Ribs, Mouser P/N: 538-22-01-3027
Molex KK crimp connectors 22-30 AWG socket, Mouser P/N: 538-0850-0032
I received a question today asking if one bonus board can control both gen2 SSRs? Yes, connect the logic control in series. That is, the cathode out of the bonus board goes to anode of SSR 1 (X1) and cathode of SSR1 goes to anode of SSR 2 (X1) and cathode of SSR2 goes to the anode of bonus board.
- Home
- Group Buys
- Ready-to-Run (RTR) SSR DC Speaker Protection and Delay GB