Re: Hi!
nope 😉
I don't do post receipt photoshoping .........
😉
it will ring ........
zeonrider said:
nope 😉
I don't do post receipt photoshoping .........
😉
it will ring ........
Because of space and ventilation issues - my (future) pumpkin will be separated from the F4 by quite some distance - 5m.
Is running a shielded RCA or XLR cable for that kind of distance an issue with regards to sound quality?
her shann
Is running a shielded RCA or XLR cable for that kind of distance an issue with regards to sound quality?
her shann
hershann said:
certainly is , but also less critical than running same length od speaker cable ;
in any case - have a life with your gadgets ; it's better that you rule them than vice - versa
Zen Mod said:
How true! Sometimes these gadgets seems to take over our home and lives and make us more miserable when they're suppose to give us joy.
her shann
Recent Email
Choky,
Understand you may be too busy to answer just now but just checking you received email about BOM ok.
Thanks,
Jim
Choky,
Understand you may be too busy to answer just now but just checking you received email about BOM ok.
Thanks,
Jim
Re: Recent Email
I lost in last time several mails on my mail server , by my mistake .......
please -resend it , don't be shy
😉
jimbo51 said:
I lost in last time several mails on my mail server , by my mistake .......
please -resend it , don't be shy
😉
Here is a temporaray pic of my Pumpie. The plexi-lid is really a nerve-wrecking piece of work!! Other than that, it goes as planned😉
🙂
Ballbearings in front are for extension rods. The rubber washers are for decoupling of the transformers!! Minor details, but important.
🙂
Ballbearings in front are for extension rods. The rubber washers are for decoupling of the transformers!! Minor details, but important.
As you can see on the previous pic, there are vent holes at the rear. I have made similar holes in the bottom plate (alu) But at the front! The plan is ; when the inner get hot, the convection will start going, pulling air out of the entire cabinet. Any ideas that you think could better my approach, is welcome! Here is a pic of the rearplate, it will get fairly packed....
🙂
BTW the earplugs are for when the Pumpkie starts singing
🙂
BTW the earplugs are for when the Pumpkie starts singing
idea ........
worth for ikea
............
great ZM strikes again ...........
put that plexie on 5mm spacers and you'll have nice venting around perimeter
worth for ikea
............
great ZM strikes again ...........
put that plexie on 5mm spacers and you'll have nice venting around perimeter
steenoe said:
nope if idea is realized as in ikea
imagine that "channel" on top of each wood side is deeper , as made for two layers of plexy
imagine that plexy is smaller in both directions for -say- 4 mm
imagine several spacers underneath plexy , also made of plexy
imagine that you have clearence of 2 mm all around perimeter , between plexy and wood
I must admit - that will be bad looking 😉