Re: Hi!
nope
I don't do post receipt photoshoping .........
it will ring ........
zeonrider said:........
Is it April fools joke?
Regards zeoN_Rider
nope
I don't do post receipt photoshoping .........
it will ring ........
hershann said:..........
Is running a shielded RCA or XLR cable for that kind of distance an issue with regards to sound quality?
her shann
certainly is , but also less critical than running same length od speaker cable ;
in any case - have a life with your gadgets ; it's better that you rule them than vice - versa
Zen Mod said:
certainly is , but also less critical than running same length od speaker cable ;
in any case - have a life with your gadgets ; it's better that you rule them than vice - versa
How true! Sometimes these gadgets seems to take over our home and lives and make us more miserable when they're suppose to give us joy.
her shann
Re: Recent Email
I lost in last time several mails on my mail server , by my mistake .......
please -resend it , don't be shy
jimbo51 said:Choky,
Understand you may be too busy to answer just now but just checking you received email about BOM ok.
Thanks,
Jim
I lost in last time several mails on my mail server , by my mistake .......
please -resend it , don't be shy
Re: Re: Recent Email
I thought you had been banned for that joke of yours
Zen Mod said:
I lost in last time several mails on my mail server , by my mistake .......
please -resend it , don't be shy
I thought you had been banned for that joke of yours
As you can see on the previous pic, there are vent holes at the rear. I have made similar holes in the bottom plate (alu) But at the front! The plan is ; when the inner get hot, the convection will start going, pulling air out of the entire cabinet. Any ideas that you think could better my approach, is welcome! Here is a pic of the rearplate, it will get fairly packed....
BTW the earplugs are for when the Pumpkie starts singing
BTW the earplugs are for when the Pumpkie starts singing
Zen Mod said:idea ........
put that plexie on 5mm spacers and you'll have nice venting around perimeter
Good idea, but bad looking
steenoe said:
Good idea, but bad looking
nope if idea is realized as in ikea
imagine that "channel" on top of each wood side is deeper , as made for two layers of plexy
imagine that plexy is smaller in both directions for -say- 4 mm
imagine several spacers underneath plexy , also made of plexy
imagine that you have clearence of 2 mm all around perimeter , between plexy and wood
I must admit - that will be bad looking
- Home
- Amplifiers
- Pass Labs
- Pumpkin preamp - ordered by Steen , official making thread