The Moderation Team would like to point out to those following this thread that the circuit shown in post #341 is potentially lethal as shown.
The commercial variant in post #343 does not suffer these issues, furthermore the addio input is isolated via a suitably rated input transformer.
The Moderation Team would like to point out to those following this thread that the circuit shown in post #341 is potentially lethal as shown.
The commercial variant in post #343 does not suffer these issues, furthermore the addio input is isolated via a suitably rated input transformer.
Please delete him.
Hi Marco, the circuit has been the subject of much discussion and it would be disruptive to remove it now. The post in quetion has been edited to give a warning. Please heed Lampiee519's advice. Sometimes it is better for these things to remain so people can learn how NOT to do things.
Hello ,
I dont' know how to tune my coils.
Do you know where can i have some explanations, please ?
I tried 5 différent starter coils.
15uh;13,5 uh;27uh,10uh and more than 27uh but no succes.
Oscillator coil is 10uh.
I tried without the 3,3nf capacitor In front of my RF coil;it works worse.This capacitor brings an amélioration.
I dont' know how to tune my coils.
Do you know where can i have some explanations, please ?
I tried 5 différent starter coils.
15uh;13,5 uh;27uh,10uh and more than 27uh but no succes.
Oscillator coil is 10uh.
I tried without the 3,3nf capacitor In front of my RF coil;it works worse.This capacitor brings an amélioration.
I'm now learning about transmitter to understand the ionovake schematic and improve my device.
I want to know how i should design my coils :
Resonance coil is OK for me, but RF choke coil is mystérious. I just builded à 90uh one(mesured,65 mm long with enameled 0,8mm copper wire on a toilet's papper roll) and tested it:
It works not so good:the flamme is weaker as with the 15uh one at first.
Most of schematic have a 100uh at the entrance of the circuit,why ?
Last edited:
Not only a choke ,look at the picture.
And @ 35mhz a 90uh coil gives 20k.
If the Anode current is 100ma,the voltage drop is 2000v.
How much is your 519 tube current ? I think it is 150ma.If your plasma speakers run at 27mhz with a 100mh RF choke, how much is the voltage drop ?
I think it's more than the voltage power supply.
But it works, and i wonder how...
And @ 35mhz a 90uh coil gives 20k.
If the Anode current is 100ma,the voltage drop is 2000v.
How much is your 519 tube current ? I think it is 150ma.If your plasma speakers run at 27mhz with a 100mh RF choke, how much is the voltage drop ?
I think it's more than the voltage power supply.
But it works, and i wonder how...
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Planars & Exotics
- Plasmatweeter