And do you have children Upupa Epops?To Angel : The same question : Have you children ?
Yes, I have and from my personal experience I know very well how " kick " high voltage . And also I know very well, how tempt little children to put pins into holes... But these things don't tell nothing to guys, which can to see on chassis phalic symbols without " cover " condom .
Do you let your children watch television? Watching television (especially sponge bob etc) can maim your children for life!
And is in my opinion a thousand times more dangerous than my valve amp...which the children are free to touch...luckily TV has not fried their brains enough ....that they are stupid enough to touch the valves!!!
And is in my opinion a thousand times more dangerous than my valve amp...which the children are free to touch...luckily TV has not fried their brains enough ....that they are stupid enough to touch the valves!!!
Hi,
Which is how you ended up having kids, I suppose.....
Cheers,
And also I know very well, how tempt little children to put pins into holes...
Which is how you ended up having kids, I suppose.....
Cheers,
KT88 PP Pix
Howdy all! My fourth project.... EF86 triode connected-> 12AU7-> KT88 triode connected PP. No negative feedback. Hammond output and power tranny's. Great forum you have going here...think I'm going to be a regular. Some damn fine looking amps here!
Howdy all! My fourth project.... EF86 triode connected-> 12AU7-> KT88 triode connected PP. No negative feedback. Hammond output and power tranny's. Great forum you have going here...think I'm going to be a regular. Some damn fine looking amps here!
Attachments
Here's a bottom shot finally! Yes chassie is 12 gauge copper. A sheet
large enough to make two amps cost me $90CND. The guy at the sheet metal shop does the cutting and bending for free. "Anything but another duct!" Kinda messy under the hood, but a lot of tinkering went on. You see 2X4H chokes under there. Overkill, but I had em so......
large enough to make two amps cost me $90CND. The guy at the sheet metal shop does the cutting and bending for free. "Anything but another duct!" Kinda messy under the hood, but a lot of tinkering went on. You see 2X4H chokes under there. Overkill, but I had em so......
Attachments
Upupa Epops said:What's sense of copper cassis ? Past one month it will be dirty black and will be look like textbook of dactyloscopy . Standard question : Have you in your flat a children ?
It is easy to stop copper from oxidising if you spray it with a clear Laquer.
Regards
Anthony
MelB said:Here's a bottom shot finally! Yes chassie is 12 gauge copper.
Hi Mel, do you use the copper chassis as part of the circuit? If so, how are electrical connections to it made?
Hi,
I'm a new member of this forum....
first: sorry for my bad english!
Last week I completed the assembly of my Dynaco ST-70 clone
the bottom
Bye, Andrea
I'm a new member of this forum....
first: sorry for my bad english!
Last week I completed the assembly of my Dynaco ST-70 clone
An externally hosted image should be here but it was not working when we last tested it.
the bottom
An externally hosted image should be here but it was not working when we last tested it.
Bye, Andrea
- Home
- Amplifiers
- Tubes / Valves
- Photo Gallery