Hi,
It is a zip file (AUD200U-copy.zip).
check your spam folder
Regards
MANOJ
It is a zip file (AUD200U-copy.zip).
check your spam folder
Regards
MANOJ
OK thank you.
Can you send me the diagrams of the AUD600 and AUD1000 amplifiers?
Thank you.
Hi,
Both one is same, only diff. is voltage and FB resistor value and OC setting changed.
Regards
MANOJ
MANOJ TM CLASS D AMP
Hi
How are you today?
you create new AMP again.
very good
can you share it with me ?
Hadi.ghr.e.61@gmail.com
are you have SMD type of this amp?
Hi
How are you today?
you create new AMP again.
very good
can you share it with me ?
Hadi.ghr.e.61@gmail.com
are you have SMD type of this amp?
Since you donot have the current limiting circuit in it, why put R6/R7 in series with the MOSFET?
My opinion is you can use IRS2092S reference design to save lots components with this output power.
..oh, this is for education, learn, how ClassD works..
Buying a cheap L15D-modul isn't helpful 4 me.
Buying a cheap L15D-modul isn't helpful 4 me.
Excuse my english. thanks for all your help to us. We are learning thaks to you and others electronics gurus. . I am using a 555 timer to sincro an IRS900 stereo but i have an oscilation up and down in frecuency.? How do you sinc two modules on the same gabinet¿. Thanks a lot.
Hi,
FSW sync. used for ideal only not for working freq. sigma delta mode it (fsw)will change when it working.
Regards
MANOJ
Thanks . You think its better to put to oscilate one amp at 250 khz and the other amp at 350 khz for example ¿¿¿
Hi,
18KHz~25Khz bandwidth is enough for eliminating crosstalk
ie: ch1 fsw=250KHz ch2 fsw=275KHz
Regards
MANOJ
I put the amplifiers to oscilate at 250khz and 288khz .The noise gone completely. Thanks again for your help and for your ideas. Thanks a lot.
