Thanks all!
@Mrshazbot I was worried I'd experience some of the problems others reported in this thread. However it worked perfectly, when I finally corrected the polarity on the PS!
It is dead quiet and a joy to listen to! The chassis are from HiFi 2000 and fit perfectly in the space I have. PS box is steel, the RIAA box is aluminum.
@Mrshazbot I was worried I'd experience some of the problems others reported in this thread. However it worked perfectly, when I finally corrected the polarity on the PS!
It is dead quiet and a joy to listen to! The chassis are from HiFi 2000 and fit perfectly in the space I have. PS box is steel, the RIAA box is aluminum.
Have my unbuilt boards to hand - Two Identical boards 5 x 7 inches or 127mm x 178mm
Thanks!!
Slimline 1U Case ordered (steel for RIA) - Thanks to some folk on here inc 6L6 I just need some 5mm standoffs and to buy short stumpy caps linked to in earlier posts and it will all fit in one long low case that I can put in front of the turntable. Systemdek with a Music master moving Iron cartridge on linear Air bearing Tonearm. Total frankenstein turntable. Project speedbox power supply too.
Pass DIY Addict
Joined 2000
Paid Member
Never really thought about this before, but how about a pair of 12v batteries that get used in grass trimmers?
Might give longer life than more "regular" types of batteries...
Might give longer life than more "regular" types of batteries...
Pass DIY Addict
Joined 2000
Paid Member
I am in the process of putting all the populated boards into their chassis and hooking them up for my Pearl 2 build. Do you know where there is a tutorial on how to hook up the transformer for the power supply? This is my first time using a transformer in a project, so I am a little nervous about screwing up and damaging something. Should I post pics of the transformer itself to make it easier?
Thanks
Thanks
Pass DIY Addict
Joined 2000
Paid Member
- Home
- Amplifiers
- Pass Labs
- Building a Pearl 2