Hello
Which pins of which connector do I have to use to upgrade the firmware when the DAM1021 is installed to SK?
Kind Regards
Phil
Which pins of which connector do I have to use to upgrade the firmware when the DAM1021 is installed to SK?
Kind Regards
Phil
Hi Audiozen,
is it possible to integrate a separat encoder only for volume control?
Or, if not. Is it possible that the default encoder function after startup is volume control?
Greetings from Germany
is it possible to integrate a separat encoder only for volume control?
Or, if not. Is it possible that the default encoder function after startup is volume control?
Greetings from Germany
Last edited:
How I'm using mine at the moment, fantastic addition. Just need to find machine shop that has some time to waste.
Last edited:
Hi,
as audiozen wrote: Use J11for the pi => it works, thanks!
@audiozen,
did you have a picture with dimensions from the mainboard?
as audiozen wrote: Use J11for the pi => it works, thanks!
@audiozen,
did you have a picture with dimensions from the mainboard?
Please see the back of PCB,All sizes are marked.Please find the attached pix.
Attachments
@audiozen,
oh yes! I remember that I saw the dimensions, it was too simple, thanks for the hint.
oh yes! I remember that I saw the dimensions, it was too simple, thanks for the hint.
I need help, please. My screen stocked on "Unlock". Everything else working properly.
Could somebody share some photo with connection between Soekris and board.
Could somebody share some photo with connection between Soekris and board.
An externally hosted image should be here but it was not working when we last tested it.
Looks like the TX should be ok, and the RX is not ok.
Show your wiring pix, please. Also, make sure your dam1021 firmware is 1.06.
Show your wiring pix, please. Also, make sure your dam1021 firmware is 1.06.