Thanks for PCB, but i prefer the already tested one in practice
to Zen Mod:
The table below gives rough guidelines of how wide to make a trace to handle the current:
0.010" (0.254mm) 0.3 Amps
0.015" (0.381mm) 0.4 Amps
0.020" (0.508mm) 0.7 Amps
0.025" (0.635) 1.0 Amps
0.050" (1.27mm) 2.0 Amps
0.100" (2.54mm) 4.0 Amps
0.150" (3.809mm) 6.0 Amps
0.236" (6mm) out of range
And that is without soldering (covering) traces with solder.
to Zen Mod:
The table below gives rough guidelines of how wide to make a trace to handle the current:
0.010" (0.254mm) 0.3 Amps
0.015" (0.381mm) 0.4 Amps
0.020" (0.508mm) 0.7 Amps
0.025" (0.635) 1.0 Amps
0.050" (1.27mm) 2.0 Amps
0.100" (2.54mm) 4.0 Amps
0.150" (3.809mm) 6.0 Amps
0.236" (6mm) out of range
And that is without soldering (covering) traces with solder.
just slightly
take a look at any of "approved" forum pcb's
in short - gate trace can be narrow
both drain and source traces must be at least 6mm wide
maybe this is better....
Attachments
I'm too much old-fashioned for that lalala
ya see some difference in approach , in enclosed pic ?
Ahh, beloved Babelfish J2 ......! Shows his face!
my soldering iron is ready just waiting for the boards it will be a nice amp for my bedroom or maybe på PC?
Hey don't you have an F5T to finish ....
Boards Ordered!!!!1!1!
they are double-sided..
& yes, the amps really are "handy to have around the house"
1001 uses.. (OK at least 10)
Also make great gifts for that special niece or nephew..
they are double-sided..
& yes, the amps really are "handy to have around the house"
1001 uses.. (OK at least 10)
Also make great gifts for that special niece or nephew..
my soldering iron is ready just waiting for the boards it will be a nice amp for my bedroom or maybe på PC?
Last edited:
Hey don't you have an F5T to finish ....
yes i do among others as: aleph30, alephJ, borbely all-fet Pre, 5.1DTS decoder, a CD player, 6ch plate amp, a sub, 5 speakers and a DAC
you already have something as "Aleph effect" implemented
look for Mu-follower explanations around
Ah ! Ok then , thanks
flotschi, the pcb looks much better now Are you gonna try it some time?
Hi mindutis,
I made some little corrections (c1 and R10 dont overlap anymore) and ordered the parts already....
tonight, i will etch a pcb for testing, and next week when the parts arrive i will test it.
- Home
- Amplifiers
- Pass Labs
- Amp Camp Amp - ACA