Hi!
I want to build this amplifier, and I have some questions. I don't want to use limiter, bridge mode and the protection. I marked some components on the picture below I think i don't need:
On the right side, I'm not sure if the two diodes (1n4007) are for the protect or the amplifier. Will it work if I remove these components?
And another question. Is +-70V enough to get about 350W at 8 ohm speaker?
Thank you for your help!
I want to build this amplifier, and I have some questions. I don't want to use limiter, bridge mode and the protection. I marked some components on the picture below I think i don't need:
An externally hosted image should be here but it was not working when we last tested it.
On the right side, I'm not sure if the two diodes (1n4007) are for the protect or the amplifier. Will it work if I remove these components?
And another question. Is +-70V enough to get about 350W at 8 ohm speaker?
Thank you for your help!
Hi!
I want to build this amplifier, and I have some questions. I don't want to use limiter, bridge mode and the protection. I marked some components on the picture below I think i don't need:
On the right side, I'm not sure if the two diodes (1n4007) are for the protect or the amplifier. Will it work if I remove these components?
And another question. Is +-70V enough to get about 350W at 8 ohm speaker?
Thank you for your help!
Amp will work, but do not remove 1N4007.
+/-70V is enough for 350W at 4 ohm .
Regards
You can draw pcb for this simple simetrical PA amp.
I hope...
Do you have the bottom side or photo of bottom side??
Regards
Find it where is was...Bass from B500 have very good definition, and I like it, but you need 'CREST' style like VERTEX for 'real hard bass' or somethin simplier like this:
Regards
This is from page 73 post #725
one more question
the maximum voltage for this amp & with how many pairs of output?
Regards
Last edited:
Hello Sir Apex
Plz share vu led meter.
Thanx and Regard
Use this circuit for amp led vu. Connect to amp with only 3 wire and no need to adjust (auto range).
Attachments
Thanx sir
but i wanted to use with mixer on out line.
Use this circuit for line level VU
Attachments
sir how add more led like -20dB, -15dB, and -5dB ?
Add LM339 for 4 more leds per channel, and you can have high resolution VU like in studios (20 leds per channel)
how much the ac voltage coming out on speaker out of h900 if in maximum volume?
B500 out 45vac,
H900 out 60vac RMS.
Last edited:
- Home
- Amplifiers
- Solid State
- 500W PA amplifier with Limiter