100W Ultimate Fidelity Amplifier

[apexaudio]

good sr mile
can you help me with this detail
regards

Do not use this resistor, there is resistor on TB3 input.

 

[lomdwrrrt]

softstart

Mr. Mile,
Thanks. Here is a compact minimalist version of your softstart with 24V relay that can be placed between switch and trafo.

regards
prasi

hello brother could you pass me pcb .pdf

 

[prasi]

hello brother could you pass me pcb .pdf

here it is.

 

[lomdwrrrt]

Thank you

 

[selwe]

Does the project posted here:
https://www.diyaudio.com/forums/sol...mate-fidelity-amplifier-1034.html#post5418835

is the same as the one shared on PCBWay:
apex ax14_total new_2pairs_rev1 - Share Project - PCBWay

?
Thank you!

 

[lomdwrrrt]

preamp

varnish drying

 

[desertstorm]

sure PM your e-mail and I'll send it to ya no problem yes I called "Golosa" but is just AX-14 with more pairs 😛



Best Regards
Juan

Sir Juan can you share the schematic diagram of your Golosa sir thanks

 

[maxwell007]

APEX DC555s stereo protect with fan control

 

[44250]

have you solved an issue with a40?

 

[maxwell007]

not yet...only one channel is OK and working well...i have no time 🙂

 

[44250]

i was solving a bias problem today - solution was to use driver transistors as assigned in schematic instead MJE15045-45 wich i used. now i have to assemble one more pcb...and enjoy at last! 🙂

 

[Sunny22g]

i was solving a bias problem today - solution was to use driver transistors as assigned in schematic instead MJE15045-45 wich i used. now i have to assemble one more pcb...and enjoy at last! 🙂

Brother is this ok PCB or not

 

[44250]

yes,that is actually the board i used,thanks to alex mm...

 

[Sunny22g]

yes,that is actually the board i used,thanks to alex mm...

What about PSU. Can u tell me

 

[44250]

for stereo,at least 750VA transformer with 2x44Vac secondary.

 

[Sunny22g]

for stereo,at least 750VA transformer with 2x44Vac secondary.

Hello brother 44*1,41=62.4 it's ac after dc.but all capacitor is 63 volt.its too high.mean 63 volt capacitor we give 62 volt.you know what I say?

 

[44250]

actually it will be +/-60V,there is 0,7V on each of two diodes in bridge rectifier. use 2x42Vac,or buy 75V capacitors.

 

[masood251]

i want fx9 pcb .please suggest me.using 0ne pair irf224 and 9240
thanks

 

[masood251]

Hi Scott


may this new routed Board will work for your need. 😉
It is mostly followed by Sonal traces, but added above traces.
Have fun.
I place my orders to KiKiPCB, like vargasmongo.


Regards.

please send me in pdf form
thanks

 

[selwe]

Does the project posted here:
https://www.diyaudio.com/forums/sol...mate-fidelity-amplifier-1034.html#post5418835

is the same as the one shared on PCBWay:
apex ax14_total new_2pairs_rev1 - Share Project - PCBWay

?
Thank you!

No one recognise this?
At least, those 10% donated should go to the right person.