I know c3 values are sensitive due to oscillation. Is wiring a low value film bypass cap only advisable on c2 or can this be done on c3 also? If wiring on c2, would this be in parallel to an elctrolytic and, if so, is the best way to wire it to the pins on the bottom side of the regulator?
Would the below be suitable at D1-D4? I have seen them recommended for my specific DAC application.
IDH04G65C6XKSA1 Infineon Technologies | Mouser
IDH04G65C6XKSA1 Infineon Technologies | Mouser
The 120 because small is certainly the faster, MSRF is TO-220 slower but also soft recovery so it's possibly a better compromise when for digital. Especially for clocks. The rf small value resistor does some RC EMI filtering with C1 in all cases though. I would be more inclined about deringing the Tx & diodes combination than finding the super suitable bridge diode type if building detailed.
What about MUR820G?Has much more pF especially before 30V reverse voltage than a MUR120 at least. To go there it takes a 22V Tx. So for low voltage output reg configurations I would prefer the others.
What about MUR820G?
Its good, still fast enough, and power (if needed) is higher than with the MUR120
If building a supply for 15vout and using VR1 with a 5k value, what would max vout be? I'd want to make sure I could get the full 15v vout in case there are minor variances in the trimmer. If not, I'd use a 10k trimmer.
I assume the below is fine to use?
3296W-1-502RLF Bourns | Mouser
I assume the below is fine to use?
3296W-1-502RLF Bourns | Mouser
Salas, I am populating Ubib board for a supply 24v./1,5A.
I am concerned M1 in it's limits using high speed Fairchild FQP3P20.
What can I expect if exceeded, a burn?
I have not in parts bin a IRF9630, but seen a pair IRF9530, maybe still useful in this application. Does it slows much the performance?
Jordi
I am concerned M1 in it's limits using high speed Fairchild FQP3P20.
What can I expect if exceeded, a burn?
I have not in parts bin a IRF9630, but seen a pair IRF9530, maybe still useful in this application. Does it slows much the performance?
Jordi
9530 is even slower unfortunately. FQP can withstand if well sinked. Worse thing to happen is baked until failure. In CCS it usually breaks open and cuts the circuit on fail because M1 is in series. Not big trouble. Not guaranteed but usually fails open, not shorted. Don't forget to fuse in any case.
- Home
- Amplifiers
- Power Supplies
- Salas SSLV1.3 UltraBiB shunt regulator