Here is the MDD 34c9 base for FaitalPro 3FE22 - build report here: My 34c9 (omnidirectional full range with 3FE22) build
Attachments
that is cool !
I think it will do better as have seen improvement with a 1.9" ID K-tube being fed from a one inch compression driver by using a 1" to 2" conic adapter.
It would be interesting to see how Akabak3 interprets this klam.
I think it will do better as have seen improvement with a 1.9" ID K-tube being fed from a one inch compression driver by using a 1" to 2" conic adapter.
It would be interesting to see how Akabak3 interprets this klam.

Last edited:
@pelanj - That looks very good and assume its quite "rigid". It will be interesting if kaameelis runs it through Akabak3 .
How much internal volume does it have vs the Karlson flat-wall version?
I keep hoping a shallow K-lens can do "reasonably" well as a tweeter device.
How much internal volume does it have vs the Karlson flat-wall version?
I keep hoping a shallow K-lens can do "reasonably" well as a tweeter device.
Last edited:
I think I could measure this in Fusion 360, before I do, my estimate is half of the volume. It is printed from leftover filament at low infill and yes, the shape is much more rigid than the first one. A flat lens directly over the speaker, maybe even with a bit of cone filling should definitely work well.
Even if the front chamber were proportionately as deep as a scaled Acoustic Control 115BK, I think results "might" be acceptable - ??
if so then "good". - if not - then would be a cute toy 😱
polyfil or Melamine sponge in the back chamber
if so then "good". - if not - then would be a cute toy 😱
polyfil or Melamine sponge in the back chamber

For a large measuring session, I printed an adapter for 3FE22 to fit on a 2" throat horn. It is now mounted on one of my 2385 clones. STL will be uploaded, too. The only catch is that it is using (like most ofmy stuff) square M4 nuts.
Attachments
These are 1". They are maybe too small, the Smith-Selsted tweeter was originally for a 1/2" driver, but the only one I know thst can be bought today is the BC DE5. I want to try them with the large multicell horn and compare them with the small one. In this case the looks is above performance, these look really terrific if made from hardwood🙂
Attached is the stl file for the Celilo II speaker that I documented here: https://www.diyaudio.com/community/...l-affordable-two-way-unity-horn.346078/page-3
Attachments
Attached is the Autodesk 123D file for the Celilo II speaker that I documented here: https://www.diyaudio.com/community/...l-affordable-two-way-unity-horn.346078/page-3
Attachments
- Home
- Loudspeakers
- Multi-Way
- 3D printed audio stuff (with STL files)