Ok. Gonna put some music to it and see what I get
Sent from my iPhone using Tapatalk
The Bias ports are turned different would will that mean one channel will be louder than the other?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
15 seconds in and the amplifier turns off and on and I hear the clicking sound twice, and I turn off as quick as possible
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Going to a local parts store tiger the original 5.1v zener diode to see if that fixes the problem
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
The zener was the problem just replaced it and it's working alright giving it a drive test
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
The zener must have failed after installing it. The difference in voltage would not have caused the amp to drop out.
I have been driving it from last night and it's working perfectly so I guess the other Zener died after a few seconds
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
So I have an issue, well I think it is I'm using the amp to play bass I'm using a bumper in a ported box tuned to 40hz it maximum rating is 420rms and the amplifier is 160 based on research and when I play music loudly I hear like the voice coil is hitting the back of the magnet could it be that the amplifier is outputting more power than the speaker can handle?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
It also makes the speaker wobble even without bass notes idk if it's the internal cross over but it wobbles even without bass notes
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
My speakers port required 3.7inch and I'm using a 3 doubt that could be the issue I would say it doesn't happen with my mei amp but I doubt it outputs this much power
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Not using any head unit just 3.5mm head phone jack and yes it does it on both channel
Sent from my iPhone using Tapatalk
The problem may be because the shield has no connection to ground as would be with a standard head unit.
Tried to power up the amplifier not too long ago and it shuts down my power supply likely a short but where
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Status
- Not open for further replies.