I own this one about 5 months:
1.It's power supply connect is 5.5*2.5, not 5.5*2.1.
2.USB port is for DSP setting, not DAC. Changing DSP settings is fun.
The only problem is: default input is bluetooth, not analogout rca input.
1.It's power supply connect is 5.5*2.5, not 5.5*2.1.
2.USB port is for DSP setting, not DAC. Changing DSP settings is fun.
The only problem is: default input is bluetooth, not analogout rca input.
I've now got it running so that the rca is the default input - by clicking off the mic input and then 'downloading' to 'flash' (aka the amp).
The annoying LED still flashes however to tell you that BT is not connected. That can't be turned off in the software.
I have been having bru5 for the past few days.
Just like few forum members pointed, I had problem with only 1 channel working. L&R being mixed up. Then it worked alright!!!!
I was driving a passive subwoofer. DSP software was very helpful. I am no expert on DSP but somehow managed to set the low pass filter and input gain🙂 and bru5 met its objective.
The biggest issue: it gets too hot quickly.
Perhaps its due to the 48v5a power supply of Aiyima.
Need to check this with something like 32v/24v supply.
Would be helpful if members can comment on this heat issue.
#wondom #bru5
Just like few forum members pointed, I had problem with only 1 channel working. L&R being mixed up. Then it worked alright!!!!
I was driving a passive subwoofer. DSP software was very helpful. I am no expert on DSP but somehow managed to set the low pass filter and input gain🙂 and bru5 met its objective.
The biggest issue: it gets too hot quickly.
Perhaps its due to the 48v5a power supply of Aiyima.
Need to check this with something like 32v/24v supply.
Would be helpful if members can comment on this heat issue.
#wondom #bru5
I guess the post didnt get the attention of the right member.
For those who are interested, this may be useful.
For those who are interested, this may be useful.