And the boat im working with, and some storage
Reminds espionage for stopping an evil top secret heavy water transportation.
Reminds espionage for stopping an evil top secret heavy water transportation.
Actually before we left to the dry-docj we had some manly consumptiom of gin and tonic on the roof top on a neighbour boat. That one had been used by stasi on the channels fot contra espionage on the european rivers. Good damn it was nice equipment in that boat.
Our boat, or my friends boat, contains around 30-40 thousand tubes. One third sorted. All the P-tubes thrown away and now were about to renovate the public areas. Well. Thers some tons of old transformers, chokes, caps, resistors and stuff also.
We unloaded 6 tons of speakers etc last week. Imperial horns, Infinitys....
Use your generator and scope for typical debug procedure then to find the fault.
100mV 1kHz, then attn -40dB, input to SUT each channel after another.
Scope SUT out, 1st stage out, second stage out, see where the signal stops and why.
Starting to catch the issue.
Yes you are right Salas, my mistake 10mA for the Itch and the rest for the 220K bleeder resistor.
Well that doesnt make sense either but its ok if you have got voltage to 300 in some way. Otherwise ohms law is good.
- Home
- Source & Line
- Analogue Source
- Valve Itch phono