hi exflaco
greetings yes its 2500 in 4 ohms bridged and using FDA mosfets power can reach 4000 watts
greetings yes its 2500 in 4 ohms bridged and using FDA mosfets power can reach 4000 watts
Pls give me the clear schematic end pcb lay out of this amp..and how much the maximum supply rail. Thanks
Hi andrew,
can you tell me the FDA series you are used , is it FDA70N20?? and in India where i can get this. now i am sitting for reducing the THD level. IRF240 THD 3.7% @ quarter Volume gate resistor 47ohm SUPPLY@+42V -42V 5A load 4 ohms. i wanted below 1% THD.
RGDS
manoj
can you tell me the FDA series you are used , is it FDA70N20?? and in India where i can get this. now i am sitting for reducing the THD level. IRF240 THD 3.7% @ quarter Volume gate resistor 47ohm SUPPLY@+42V -42V 5A load 4 ohms. i wanted below 1% THD.
RGDS
manoj
http://www.youtube.com/watch?v=WDQcq...ature=youtu.be
3 pair dclass amp using IR2110 mosfets used IRFB260Nwarm regards
andrew lebon amp made by sir irvynejay
3 pair dclass amp using IR2110 mosfets used IRFB260Nwarm regards
andrew lebon amp made by sir irvynejay
i see all page of this thread
please advice me to create on of the amp in 2 ohm stabel.
thanks
please advice me to create on of the amp in 2 ohm stabel.
thanks
where to get the schematic for this design ?
Do you sell this pcb ?
or can you share files for pcb supplier ?
waht pcb design software do you use ?
on top is a jbl class d amp
at the bottom is class d amp tl071-cd4049-2110-61n20 fets inductor is 100uH
An externally hosted image should be here but it was not working when we last tested it.
class d amp using IR2110 as driver with output fets irfb4227 and cs core 28t #18 magnet wire
