Hello,
Thanks everyone for replying, i went with sticking to the plan. Used a flush router bit with a smaller bearing, and then a normal flush router bit for the second half. Short work if you have carpenter friends who tell you the tricks. Im giving the magnets a little black paint so they sound better.
Some more pictures!
Ill keep you guys posted!
Thanks everyone for replying, i went with sticking to the plan. Used a flush router bit with a smaller bearing, and then a normal flush router bit for the second half. Short work if you have carpenter friends who tell you the tricks. Im giving the magnets a little black paint so they sound better.
Ill keep you guys posted!
Finally cut some wood to start on xsd cabs. The base of the wings elongate in yours, but I don't have enough wood to do the same thing, at least in one piece. Would it be detrimental to just make the wings a straight board? I'll still cut out the angle on the top. If so, I'll just make an extra piece and glue it on
Yes, that’s fine. The elongation at the base provides stability so it doesn’t tip over. There is some nominal increase in bass extension but not much.