18 inches and 40.4mm Xmax / 53mm Xlim
http://pasub.com/PASUBLine.pdf
I don't know if these are still available, but Wi, you seem to be a bit of an Xmax Junkie...
Regards, Ben
http://pasub.com/PASUBLine.pdf
I don't know if these are still available, but Wi, you seem to be a bit of an Xmax Junkie...
Regards, Ben
Been away for a couple of weeks pre-wiring wiring a house. 3.5 miles of cable including 8500ft of 16/4. Wheeee.
I'll be kicking this project back into gear soon.
I'll be kicking this project back into gear soon.
Doesn't look like this will be loaded with the 5100.
Through all the sims and curves the 5100 would do better for the same pack space in a reflex enclosure.
I still may build a reflex one for kicks, but the horn lives on.
Through all the sims and curves the 5100 would do better for the same pack space in a reflex enclosure.
I still may build a reflex one for kicks, but the horn lives on.
I had actually ended up deciding on using the Epic 10". Simulations showed that using 6 smaller horns at 500w each hit 140 at 20hz.
The 5100Neo ended up in a refrigerator sized enclosure, and stacking reflex boxes proved the better option as it had to be mobile. The LMS-R12 faced the same issue.
6 smaller boxes that soak up more power and are easier to move than a large one seemed the way to go.
Then I ran out of money to continue pursuing the project, so it is on the back burner right now.
The 5100Neo ended up in a refrigerator sized enclosure, and stacking reflex boxes proved the better option as it had to be mobile. The LMS-R12 faced the same issue.
6 smaller boxes that soak up more power and are easier to move than a large one seemed the way to go.
Then I ran out of money to continue pursuing the project, so it is on the back burner right now.
140 dB per box @ 20 Hz
Now that is impressive!
Is this still a tapped horn, similar to the one JBell suggested?
Are these epically huge?
Regards, Ben
P.S. Yes, I want one, or 2, or however many I can transport.
Now that is impressive!
Is this still a tapped horn, similar to the one JBell suggested?
Are these epically huge?
Regards, Ben
P.S. Yes, I want one, or 2, or however many I can transport.
Not quite, I think he meant as a total from 6 boxes and 3KW. I do wonder if that's a 2 pi figure though???
A little clarification...from the guy with the model....😀
Good to see ya Wi.
That is a 1pi number, (wall loaded) as Wi typically does indoor gigs. I feel 0.5pi is too optimistic, even for indoors and corner loaded situations.
The simulations show 90 dB+ at a watt in, and will take 500 watts within xmax. To get to 140 dB at 40 Hz, it takes a total of 6 cabinets, each fed 500 watts.
These are tapped horns, approximately 300 L net, so they'll be 12 to 13 cubic feet when folded. Since Wi slowed down on this little project, I did not ever fold one for him. I'm ready when he is, but for those of you that don't fully know the pace at which I fold a sub.....don't hold your breath waiting. 😀
hey it's mike and wi... it's a party!!
how's bowling? any 300 games?
Mike, glad you got wi a reasonable sized cabinet -- I never quite got to 140 for him on things I simmed. dayton titanic 10 with 100-620cm2 with a 500cm length got 137@20hz/400watts per/8cabinets/1pi.
A bunch of epic10's is a whole lot more reasonable than the 5100/refrigerator...
what do you think mike --- insubnia maxima?? Many folks would love to see something like that if you ever get the time.
how's bowling? any 300 games?
Mike, glad you got wi a reasonable sized cabinet -- I never quite got to 140 for him on things I simmed. dayton titanic 10 with 100-620cm2 with a 500cm length got 137@20hz/400watts per/8cabinets/1pi.
A bunch of epic10's is a whole lot more reasonable than the 5100/refrigerator...
what do you think mike --- insubnia maxima?? Many folks would love to see something like that if you ever get the time.
- Status
- Not open for further replies.