Greetings...
My SR200 now has dc offset 5mV and 2mV...biased at 7mV at r 0.33 ohm (21mA)...R and C on zobel network are warm tends to hot after more about 15-20 minute that I think start to oscillate.
I use standard SR200 schematic with 20pf capacitor which is soldered on the cooper side of pcb.... I have no scope at moment...
Would you please advice me what the best practice is.... thank you so much...
Best regards
Arif
My SR200 now has dc offset 5mV and 2mV...biased at 7mV at r 0.33 ohm (21mA)...R and C on zobel network are warm tends to hot after more about 15-20 minute that I think start to oscillate.
I use standard SR200 schematic with 20pf capacitor which is soldered on the cooper side of pcb.... I have no scope at moment...
Would you please advice me what the best practice is.... thank you so much...
Best regards
Arif
I am sorry for asking, just for sure....do you mean bigger compensation caps?
Best Regards,
Arif.
What are the specs? Are there measurements? Are there kits available or how much would it cost to build?
Hi Friends,
I have completed the SR200 amp and it is working. But when I am using RCA cables for loud speakers connection then hum noise is noticed if i put my ears close to speakers.
Please advise what need to be done to stop the hum noise.
Regards,
Samrat
I have completed the SR200 amp and it is working. But when I am using RCA cables for loud speakers connection then hum noise is noticed if i put my ears close to speakers.
Please advise what need to be done to stop the hum noise.
Regards,
Samrat
APEX HV23
Hello apexaudio,
I am going to build an APEX HV23, you have advice for this project?
thanks
🙂🙂
http://i56.servimg.com/u/f56/16/58/26/85/2013-111.jpg
Hello apexaudio,
I am going to build an APEX HV23, you have advice for this project?
thanks
🙂🙂
http://i56.servimg.com/u/f56/16/58/26/85/2013-111.jpg
There is thread for more informations about HV23
http://www.diyaudio.com/forums/solid-state/162043-mosfet-amplifier-irfp240-irfp9240-71.html