I built Rod Elliiots P3 using bd139/40, the mje drivers, and tip2955/3055. Doubled the OP devices and bits as per suggestions in the article. P3A is apparently better but the P3 was good enough ��
It wad awesome once i had sorted a ground issue i had.
It wad awesome once i had sorted a ground issue i had.
Kits of thailand🙄
The wirewound resistors need only to emitters, NOT to collectors.
Qsc clone
this is was tested sir..?
Collector grounded amp😉
warm regards
andrew lebon
this is was tested sir..?
Dear sir i am interested in such type of amplifier would you like to share with meUpgade ver. of 741
M****N 741 1000w
Supply -+100/10A
clear and punchy sound
7+7 5200+1943 Trans.
Based on TEF Technology
- Status
- Not open for further replies.
- Home
- Amplifiers
- Solid State
- SIMPLE AMP