Hi Marcel.
This morning I received a white envelope with the PCBs.
Is it possible that it is the first shipment? I think it's very fast if it's the shipment you made earlier this week ...
If I receive the "lost" shipment, I can return that PCB set to you.
Be aware, I will notify you if I receive the other shipment.
Best,
Francisco
This morning I received a white envelope with the PCBs.
Is it possible that it is the first shipment? I think it's very fast if it's the shipment you made earlier this week ...
If I receive the "lost" shipment, I can return that PCB set to you.
Be aware, I will notify you if I receive the other shipment.
Best,
Francisco
Here a picture as I could not attach a picture via PM. They are 185 x 230 mm. I don't count the part without fins as I would cut that off. Fins are 40 mm. Material is cast aluminium. I have a few of these left. The work is to cut the part without fins off and then cut them in the middle leaving 6 hopefully rightly sized heatsinks. Hint: AFAIK you never published size of the boards...
Attachments
Last edited:
The boardsize is 80x87 mm.
Sorry to say that these sinks do not do the job for me. The solution on the photo was a to bridge the gap to the delivery of the 2 pieces of heatsink that were due. They are 220x85mm and 3meters in length.
Im confident that that supply will tast for the comming years......
Sorry to say that these sinks do not do the job for me. The solution on the photo was a to bridge the gap to the delivery of the 2 pieces of heatsink that were due. They are 220x85mm and 3meters in length.
Im confident that that supply will tast for the comming years......
That is acting as heatsink.....With the new heatsinks I can increase the Iq to 1,2 Amp at 28V supply. total dissipation then will be 240W (120W per side) with 150mm high sinks.
Sink temp will then be around ambient + 23C
Tested the sinks with 120mm length but that was not sufficient at +28C
Sink temp will then be around ambient + 23C
Tested the sinks with 120mm length but that was not sufficient at +28C
- Home
- Group Buys
- PCB for the HAWK A18 amplifier (+ FETs if required)