thanks, understand, i need to cut it short then. The radius is 33mm, it should be roughtly 137mm long if i follow the metal cone specification or 114mm long for paper cone specification. Now my existing Port is 150mm. I probably need to cut it shorter to somewhere in between 137-114mm.
Now, the sound is ok but i am still waiting for burn in.
Now, the sound is ok but i am still waiting for burn in.
Last edited:
Markaudio are lousy at updating their site, but FWIW, I've done quite a few more enclosures than are currently there. I'm no Dr Griffin, but in the meantime these might be of interest:
Attachments
Thanks Scott. Can you please tell us what will be the FB and F3 in case of Sea Stack ML-TL?
F3 is a useless number. F6 in the mid 30s, F10 high 20s, in room they will be lower. Almost as low as in FHXL.
dave
I'll dig it out. But Dave is quite correct, F3 is borderline meaningless for acoustic purposes (it's basically a holdover from the electrical filter theory T/S values & Small's alignments were based on); it was included 'just because', not because it has any value, and I regretted doing so almost as soon as I put the drawings up.
- Home
- Loudspeakers
- Full Range
- Mark Audio Alpair 10.3/A10p MLTL