Just a quick question regarding the limiting on these subwoofers. I'm running 4 of these cabinets loaded with b&c tbw100@8ohm. One pair of cabinets is powered by a matrix xt7000mf, one cab pet channel. The other pair is run on an admark ad42, one cab per channel. All of this is controlled via a t. Racks 408, I've had issues in the past with the drivers getting toasty and dialed back the compressors but had problems with overall volume. Looking at my settings, I've realized I didn't know anything about the compressor and set it up totally wrong, currently the attack is set at 1ms and release at 1000ms with the voltage set to around 97v. Your first post mentions a 500ms time constant, is this in reference to the attack time? Also If so, if I set it slightly conservatively at 450ms attack and 1500ms release and 77v, would this be a safe bet and give us a little more Just a quick question regarding the limiting on these subwoofers. I'm running 4 of these cabinets loaded with b&c tbw100@8ohm. One pair of cabinets is powered by a matrix xt7000mf, one cab pet channel. The other pair is run on an admark ad42, one cab per channel. All of this is controlled via a t. Racks 408, I've had issues in the past with the drivers getting toasty and dialed back the compressors but had problems with overall volume. Looking at my settings, I've realized I didn't know anything about the compressor and set it up totally wrong, currently the attack is set at 1ms and release at 1000ms with the voltage set to around 97v. Your first post mentions a 500ms time constant, is this in reference to the attack time? Also If so, if I set it slightly conservatively at 450ms attack and 1500ms release and 77v, would this be a safe bet? Would I benefit from a longer release time?