hello tea bag . I am ALOPA . I have not received your email requesting payment. for 2018 Salas Boards GB #2 . I have requested 1 PCB and two + 5 volt parts kits and one minus 5 volt parts kit. Please send me the payment email so I can pay by PayPal.
Signed for PCB and 1x +5V MiniKit. Thanks Tea-Bag.
Order added to the spreadsheet. Thanks Tea.
You have all been invoiced. dvb is already paid.
Have you left a few PCB-s, I would buy 8pcs.(4 +,4-)
Responded via PM.
Hi!
When is the next time you start taking orders?
I want to order 2 sets of +5 volts and 2 sets of +6.2 volts.
I can put you on the wait list for two boards if you like. Minkits are optional.
I may have extra stock from this GB.
Is it still possible to order boards?
I can put you on a wait list for one or more boards. I cannot make any promises.
Can I get on the wait list for one board, one positive minikit, and one negative minikit, please?
Please add me to the wait list as well, Thanks!
Both are added to wait list.
Thanks.
Is it still possible to order boards?
Tea-Bag
Please put me on the wait list for 2 boards.
2 5V minikits
1 pos minikit
1 neg minikit.
Thank you,
-Josh
you are added in to wait list.
Just a note.
The original orders are all shipped out. I still have some work to do on getting the extras out, but there are boards available.
Do note.
for users who wanted 5V usage, at a minimum, I added a PF5102 measured < 7.5MA IDSS into a seperate pink static bag for use in J3. I also included Red LEDS in there, or in the minikit bag as well, as those are needed to maintain a 5V output. I was less generous with green and red LEDs this GB, as the favorite Red Kingbright LED where made obsolete, with no extra stock to be found. So I used the minimum needed.
Green Kingbrights the default for the kits, would raise that higher than 5v - but they match the Nichicon ES caps nicely otherwise.
So, this may add some confusion, and if you read this, it may clear it up.
The original orders are all shipped out. I still have some work to do on getting the extras out, but there are boards available.
Do note.
for users who wanted 5V usage, at a minimum, I added a PF5102 measured < 7.5MA IDSS into a seperate pink static bag for use in J3. I also included Red LEDS in there, or in the minikit bag as well, as those are needed to maintain a 5V output. I was less generous with green and red LEDs this GB, as the favorite Red Kingbright LED where made obsolete, with no extra stock to be found. So I used the minimum needed.
Green Kingbrights the default for the kits, would raise that higher than 5v - but they match the Nichicon ES caps nicely otherwise.
So, this may add some confusion, and if you read this, it may clear it up.
The goals were: 1. In production parts...
Oh my, times go by that fast?!
...the favorite Red Kingbright LED where made obsolete...
I measured a whole pot of Vishay TLDR4400 for a couple of Hypnotize boards and found them to have a nice tight Vf distribution around 1.8V - perhaps an alternative?
- Home
- Group Buys
- GB For Salas SSLV1.3 Ultra-BIB