Im going to wait until the electricity to go on as its loadshedding then i can post all the voltages of the 494
I had to look up loadshedding. I'd never heard of that.
1k should be low enough.
Are the FETs in or out of the amp right now?
1k should be low enough.
Are the FETs in or out of the amp right now?
Yoh it must be nice not to have loadshedding in your country. The fets are out aswell as the buffer transistors
Did you have 11v feeding back to the 494 with the FETs out of the circuit?
Did you see straight DC feeding back to 9/10 on the scope?
Did you see straight DC feeding back to 9/10 on the scope?
Yes its was from the 494 straight to the gate with minor voltage differences because of the resistors
Then i removed the fets then still saw that voltage then i removed the buffer transistors then i saw a different voltage on the 494
Pins 3 and 4 are used for control and can be OK with a variety of voltages. Which link are you referring to?