• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

DX Blame Group Buy

Status
Not open for further replies.
Jump to Latest
#86
Hey all,

you will really love this "bending tool".
It fits all the small resistor / diode sizes on inch and mm.
In each case, it's worth the € anyway...

I'm using this tool for years and i don't want to miss it.
Just my :2c:.

Have fun 😉.
 
#90
@Royalbee:

Are you really sure you want to order 4 LS Protect PCBs?

The LS Protect circuits needs 21 - 25 VAC (!) - after rectifying: 28VDC≤VIN≤40VDC - and common GND as input.
Do these requirements meet your installation?

Best regards - Rudi_Ratlos
 
#98
I've been working at putting together parts orders (DK and others)... DK seems to be out of stock on the BOM listed part for C1 (with no indication of when they will be available). I'm wondering how critical that particular part is to the board (sound quality?? etc).

I'm also wondering about how to find the "EPCOS MKT 10µF, stacked-film technology, uncoated" caps that Rudi's pictures show in C1 on his red/blue boards.

Anybody have any suggestions???

Looking forward to building this amp!!!

Thanks,
 
#99
@Sandbasser:

I have some (very few) Vishay/Roederstein 1820 10µF MKT left. Please have a look at the PCB's picture in the 1st post of this thread.
If you want to I will give you 2 of them.

@Parb:

I will tell you tonight.

@Toufu:

I am running out of stock concerning PSU- and LSProt - PCBs. But I have still some DX Blame AMP PCBs left. I will count you in for 2 of them.


Best regards - Rudi_Ratlos
 
Last edited:
Status
Not open for further replies.
Top Bottom